交换机怎么怎端口先判断流量的大小，流量峰值?
交换机怎么查看端口的流量为多少M？突发流量的大小？如下面的端口信息。
组网及组网描述：
S12508]dis int ten 1/2/0/1
Ten-GigabitEthernet1/2/0/1
Current state: UP
Line protocol state: UP
IP packet frame type: Ethernet II, hardware address: 3822-d659-3800
Description: to-server
Bandwidth: 10000000 kbps
Loopback is not set
Media type is optical fiber, Port hardware type is 10G_BASE_SR_XFP
10Gbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is autonegotiation
Flow-control is not enabled
Maximum frame length: 9216
Allow jumbo frames to pass
Broadcast max-ratio: 100%
Multicast max-ratio: 100%
Unicast max-ratio: 100%
PVID: 1
MDI type: Automdix
Ethernet port mode: LAN
Port link-type: Trunk
VLAN Passing: 45-47, 99, 2000, 3000, 4000
VLAN permitted: 4-5, 13, 30, 45-48, 99, 1105, 2000, 3000, 4000
Trunk port encapsulation: IEEE 802.1q
Port priority: 2
Last clearing of counters: Never
Peak input rate: 26866530 bytes/sec, at
(0)
最佳答案
峰值流量：
Peak input rate: 26866530 bytes/sec, at
最近300s的平均流量，如需关注实时流量，可以通过命令将端口统计时间调成5s即可
Last 300 second input: 2160 packets/sec 1266750 bytes/sec 0%
Last 300 second output: 5520 packets/sec 2483000 bytes/sec 0%
(0)
暂无评论
总流量大小看Input和output方向的total总量。
Input (total): 18490225966 packets, 18545234787064 bytes
Output (total): 28109675695 packets, 12190049788091 bytes
突发的流量大小看不到。
(0)
暂无评论
input和output峰值：
Peak input rate: 26866530 bytes/sec, at
最近5分钟平均流量大小及占总带宽百分比：
Last 300 second input: 2160 packets/sec 1266750 bytes/sec 0%
Last 300 second output: 5520 packets/sec 2483000 bytes/sec 0%
(0)
暂无评论
